The Samsung Galaxy Buds Pro has two selectable active noise canceling settings: low and high. Both settings work quite well considering it is a pair of true wireless earbuds. If you want to attenuate more low-end noise, such as airplane rumbles or the sound of your dishwasher, you should go with the high setting. On the other hand, if you want to block out more mid-range noise, such as people talking, go with the low setting, though it won’t completely cancel out human speech.

https://www.soundguys.com/apple-airpods-pro-vs-samsung-galaxy-buds-pro-47024/

LXF303

https://en.m.wikipedia.org/wiki/Recoll

As found here, you must replace every occurrence of archive.raspberrypi.org or mirrordirector.raspbian.org by legacy.raspbian.org, which is an official site.

Source: software installation – Why doesn’t Raspbian apt-get resolve package version correctly? – Unix & Linux Stack Exchange

Source: ADSLPPPoE – Community Help Wiki

[Dialer Defaults]
Init1 = ATZ
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Modem Type = Analog Modem
ISDN = 0
Modem = /dev/ttyUSB2
Baud = 9600

[Dialer thenet]
Phone = *99***1#
Username = thenetuser
Password = thenetpw
; Username = 9180****** (If your provider use without Username)
; Password = 9180****** (If your provider use without Password)
Stupid Mode = 1
Baud = 460800
Init3 = AT+CGDCONT=1,"IP","apn.thenet.net"

[Dialer mypin]
Init4 = AT+CPIN=1234

Source: Wvdial – ArchWiki

Create the wvdial config file

• The next step is to create a config file for wvdial so you can connect to your service provider.
• Open a terminal window and enter:

sudo leafpad /etc/wvdial.conf

• Replace the content of the file with the following.

[Dialer 3gconnect]
Init1 = ATZ
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Init3 = AT+CGDCONT=1,"IP","internet"
Stupid Mode = 1
Modem Type = Analog Modem
ISDN = 0
Phone = *99#
Modem = /dev/gsmmodem
Username = { }
Password = { }
Baud = 460800

• Replace internet with your service provider’s APN
• Replace the Phone number if you need to dial a different code to connect.
• Replace Username and Password if needed. To leave the username and password as blank use { }

Source: How to setup a USB 3G Modem on Raspberry PI using usb_modeswitch and wvdial | How To | The Fan Club | dynamic design solutions